Solutions to belt slip of flexo folder gluer machine

I believe many manufacturers have experienced the problem of belt slip of flexo folder gluer machine. Here are the solutions to belt slip of flexo folder gluer machine.

1. Check whether the load of the belt of flexo folder gluer machine exceeds the standard. If the load is too large and exceeds the capacity of the motor, it will be easy to slip. Although the slip at this time can protect the motor, it is necessary to adjust the feeding amount in time and control it within the maximum load to avoid material slip. This situation is relatively rare.

2. It is easy to cause the belt of flexo folder gluer machine to slip if the starting speed is too fast. In view of this situation, the starting speed can be adjusted appropriately and the slow starting can be used to effectively prevent the customer from slipping.That’s one of the solutions to belt slip of flexo folder gluer machine.

3. Slip caused by insufficient friction between the transmission drum and the conveyor belt shall be eliminated. Usually, this is caused by water on the conveyor belt or humidity. A blower can be used to blow the rosin powder on the drum.It is one of the solutions to belt slip of flexo folder gluer machine.

4. Check the tension of the flexo folder gluer machine belt. If the tension away from the drum is not enough, it is easy to slip. To solve this problem, customers should timely correct the tensioning device and increase the initial tension of the belt.This is one of the solutions to belt slip of flexo folder gluer machine.

5. If the tail roller bearing is damaged or the upper and lower idler bearings are seriously damaged, it is also easy to slip. The reason for the damage is that the tail floats and sinks too much, and the damaged or inflexible rotating parts are not repaired and replaced in time, resulting in increased resistance and slipping.